Technical Requirements for Installing Solar Road Studs

Solar road studs are installed on the road to ensure travel safety, but incorrectly installed solar LED road studs cannot ensure people’s travel safety and may also become traffic obstacles. Therefore, the correct installation of solar powered road studs is very important. In the following article, let’s discuss the technical requirements for installing solar road studs.

Solar powered road reflectors are powered by sunlight, so they should be installed in sunny areas to avoid being blocked by tall buildings or trees to ensure that they can receive sufficient sunlight.

Clean the installation location thoroughly to ensure that the road surface is flat and free of debris, expansion, cracks, and unevenness. At the same time, the road surface should be kept dry to avoid installation in water, moisture, and oily locations to prevent the solar road studs from falling off.

We recommend using epoxy resin glue as an adhesive for installing solar powered road studs due to its high strength and good weather resistance after curing. Avoid using materials that are easy to soften, such as asphalt glue. In addition, you need to prepare tools such as an electric hammer, ruler, knife, small glue bucket, chalk, generator, electric drill, glue stirrer, etc., to perform installation steps such as drilling, mixing glue, and applying glue.

Use a ruler or ruler to determine the installation position of each solar road stud, and ensure that each position is in a straight line vertically and aligned horizontally.

Embedded installation of solar led road studs requires drilling holes, and a suitable drill bit should be used to avoid damage to the road surface or road studs. If a raised installation is used, apply glue directly and ensure that the glue is evenly applied and the amount is moderate.

Press the solar powered road reflectors tightly on the installation position, ensuring that the direction is correct and perpendicular to the ground. At the same time, pay attention to the correctness of the line connection, especially the positive and negative poles of the power supply.

After installation, use a knife to scrape off the glue overflowing around the solar led road studs and clean the road surface.

After installation, regular patrol inspections should be carried out to ensure that all solar powered road studs are not installed upside down, crooked, or pressed and to check whether they are falling off or damaged.

Clean the surface of solar road studs regularly to prevent dust, dirt, etc., from affecting their reflective effect.

Check the power supply of solar powered road reflectors regularly to ensure that they continue to work normally. Especially after rainy weather, check whether the battery power is sufficient.

Correctly installing solar powered road studs according to the above steps is crucial for their normal use and due role. As an important traffic safety infrastructure, correct installation and maintenance of solar road studs can effectively extend their service life and ensure their long-term effective operation.