Due to the superior lighting function and warning function, solar road stud can be installed in the following places: road marking side, tunnel entrance and exit, vibration marking, low light section. In the poor light section, the role of solar road stud can play to the extreme. During the day, solar road studs silently absorb sunlight and convert it into electricity. At night, a small solar road stud can emit light that can be seen from 800m away.
solar-road-stud
Attention should be paid to when installing the solar road stud: first of all, the installation position of the solar road stud should be determined. Then drill the hole with a suitable size diamond bit. The drilling depth needs to be determined according to the size of the solar road stud, neither too deep nor too shallow, otherwise it will cause damage to the solar road stud.
After that, clean up the inside and near the hole of the solar road stud, and inject an appropriate amount of epoxy resin (or dolomite glue or asphalt glue) into the hole of the solar road stud. Finally, put in the solar road stud and rotate it slightly until it adheres evenly to clean up the excess adhesive.
solar-road-stud
It should be noted that the base of the solar road studshould be 1 ~ 2mm higher than the road surface. And when installing the solar road stud, we must ensure that the surface of the solar road stud is not contaminated with glue, otherwise the reflective effect of the solar road stud will be weakened.
